Are You Looking For SpeedyBee F405 WING MINI Fixed Wing Flight Controller In Australia?
Specifications
-
SpeedyBee F405 Wing Mini FC Board
- MCU STM32F405, 168MHz, 1MB Flash
- IMU(Gyro&Accelerometer) ICM-42688-P
- Barometer SPL006-001
- OSD Chip AT7456E
- Blackbox MicroSD Card Slot
- UART 6 sets (USART1, USART2, USART3, UART4, UART5,
- UART6 - Dedicated for Wireless board Telemetry connection)
- I2C 1x Used for magnetometer, digital airspeed sensor
- ADC 4x (VBAT, Current, Analog RSSI, Analog AirSpeed)
- PWM 12x (9x pin headers + 2x solder pads + 1x "LED" pad)
- ELRS/CRSF Receiver Supported, connected to UART1
- SBUS Built-in inverter for SBUS input (UART2-RX)
- LED 3x LEDs for FC STATUS (Blue, Green) and 3.3V indicator (Red)
- Analog RSSI Supported, Named as "RS"
-
Dual Analog Camera Switching Default to Camera1 Video Input (C1). Switch between C1 and C2 using ArduPilot Relay or INAV Modes/USER.
- Both cameras should have the same video format, either PAL or NTSC.
- Supported FC Firmware INAV: SpeedyBeeF405WING (default)
- ArduPilot: SpeedyBeeF405WING
- Weight 5.6g
- MCU STM32F405, 168MHz, 1MB Flash
-
SpeedyBee F405 Wing Mini PDB Board
- Input voltage range 7~26V (2~6S LiPo)
- Battery Voltage Sensor Connect to FC board VBAT, 1K:10K (Scale 1100 in INAV, BATT_VOLT_MULT 11.0 in ArduPilot)
- Battery Current Sensor 80A continuous, 150A peak Connect to FC board Current (Scale 195 in INAV, 50 A/V in ArduPilot)
- TVS Protective diode Yes
- FC BEC output Output 5.2V +/- 0.1V DC Continuous current 2 Amps, 3A Peak Designed for FC, Receiver, GPS module, AirSpeed Sensor, Telemetry module
- VTX & Camera power supply The VTX power interface Vv offers two power supply options: direct battery voltage or integrated BEC 5V (sharing the 5V4A Servo BEC voltage)
- By default, it is set to battery voltage (Ensure the VTX and camera input voltage range is compatible)
- Switching to 5V power supply is possible via pad jumper (using Servo BEC output)
(If using this method, ensure the current requirements for both servo and VTX are sufficient) - Servo BEC output Output 5V +/- 0.1V DC Continuous current 4 Amps, 5A Peak Voltage adjustable, 5V Default, 6V via jumper Designed for Servos.
- Weight 5.5g
- Input voltage range 7~26V (2~6S LiPo)
-
SpeedyBee F405 Wing Mini Wireless USB Extender
- Wireless Configuration (long press BOOT button for 6 seconds to switch modes)
- INAV:Please make sure the MSP switch on UART 6 is turned on and set to a baud rate of 115200 ArduPilot:Please make sure the Serial 6 is set to baud rate 115200 and protocol Mavlink2 BLE mode, connect to Speedybee APP
-
Wi-Fi (AP)mode, able to connect to Speedybee APP, QGroundControl APP, MissionPlanner, etc. WiFi: Speedybee eFLY-WIFI Password: 88888888
- Wi-Fi (STA)mode, able to connect to QGroundControl APP, MissionPlanner, etc.
- Step 1: turn on Personal Hotspot;
- Step 2: Set hotspot, locate NAME/Device Name/Hotspot name/etc.
- Step 3: change the current name to eFLY and the password is, 88888888
- Wireless off mode
- USB Port Type Type-C
- Buzzer 5V Active Buzzer
- Weight 3.2g
- Wireless Configuration (long press BOOT button for 6 seconds to switch modes)
Browse More
- Browse All Speedybee FC
- Browse All F4 Flight Controllers
- Browse All Flight Controllers
Why Choose Phaser FPV?
Here’s Why 1000s of Buyers Trust Us
In the sky-high world of FPV drones and related products, Phaser FPV takes you higher and further – while ensuring a smooth ride every step of the way. As a human brand that puts its clients first, here are a few of the ways we keep giving our customers reasons to come back.
Same-Day Ship
If you place your order with us before 1pm weekdays, we’ll ship it out on the same day you shopped. When we make a promise, we keep it. You’ll be hard-pressed to find any Phaser order that didn’t fly out of our facility on the day it was ordered.
Transparent Stock
We keep our website updated like hawks. If you see it and it says it’s in stock, you can order it today and get it tomorrow via express shipping.
Highly Rated
We’ve spent almost a decade racking in countless 5-star reviews. Give them a read and you'll see everything we have said here is true!
Walk In Anytime
Can’t wait? Then don’t. We’re one of the only FPV drone + accessory stores to have a physical brick-and-mortar establishment in Somersby NSW Australia.
Tech Precision
Our handpicked team of technology experts specialize in – and are boffins on – every product we sell. This means they can answer any and all of your technical questions with confidence. Go ahead, put us to the test.
Fast Support
We welcome our customers to reach out to us via email, phone, or LIVE chat. Phaser FPV is the only FPV business to have a dedicated phone line.
Get Rewarded
Score a FREE gift on first and recurring orders, and discount shipping on orders over $99.
We’re on Social
We have nothing to hide. Follow us on social, tag @PhaserFPV, and become a part of our online community and family in our facebook group.
It’s clear to see why most of our business comes through word-of-mouth referrals. When you need the best in FPV & 3D Printing don’t settle for less. Demand the best – insist on Phaser FPV.