iFlight Nazgul Evoque F5 4S/6S w/Caddx Polar Vista HD System

$515.00

CURRENTLY IN STOCK

Option one: 4S

  • 4S
  • 6S

Option two: TBS Crossfire RX

  • TBS Crossfire RX
  • FrSky R-XSR RX

Option three: F5D DeadCat Frame

  • F5X Squashed X Frame
  • F5D DeadCat Frame
$515.00
Out of stock

Order in H, M, Seconds (before 1pm AEST) for same day despatch
Add to Wishlist
SKU: 20332N/ACategories: BNF Quads , iFlight , Tags: BNF, HD, iFlight, Nazgul5

Are you looking to buy an iFlight Nazgul Evoque F5 HD BNF with Caddx Polar Vista in Australia?

The Secret Of Ultimate Performance Is Passion

That was the slogan for our newest approach to creating this piece of art! Fully protected electronics, fully illuminated, coupled with all the latest and greatest electronics we can offer. Months of engineering went into this BNF and all the lessons learned before, making sure that beginners, as well as experienced pilots, would fully enjoy using the new Nazgul Evoque from the first second they use it.

Lightweight Side Panels - Keep Your Rig Clean

Ever felt like a lawnmower cutting through the grass in your early days, props cutting and throwing wet grass all over and inside your flight stack? Well... These days are over! The new side panels will not only protect from wetness but also protect the internals from any strikes hitting off little components from your flight controller. 

Secured Integrated XT60 Battery Plug - As Safe, It Can Be

Dangling battery plugs will ALWAYS find a way in your props, there's always that one time you forgot to secure it properly and almost cut off the cable while flying. There was only one way to get rid of that and we think we might have found a solution. The integrated XT60 connector on the back lets you securely plug in your battery leading all cables away from your props.

High-Performance Electronics - F7 55A Power Stack

Our SucceX Mini F7 TwinG flight control with Gyro Fusion technology, modern USB type-C plug, 32MB flash for every tuning session, and 5 UARTs for whatever equipment you might possibly wanna use. Power from the gods with our new SucceX Mini 55A ESC packed with better heat-dissipating Mosfets and a whole bunch of SMD capacitors to filter out possible motor noise, besides the pre-soldered directly installed Capacitor right next to your battery leads.

XING2 Performance Motors - The Best Motors Just Got Better

7075 aluminum bell, 5mm titanium alloy shaft, NSK durable bearings, Center slotted magnets for better response, and lower air gaps for a higher magnetic flux with increased performance and efficiency. Not to mention the typical XING damping ring between the bell and bearing to increase durability and smoothen out your flights. 

Illumination - Let It Be Green

360-degree illumination for day and night. Maybe the prettiest BNF out there but also a practical one. The bottom light indicates battery voltage, a quick check gives you a hint of the voltage still remaining; Never lift off with an empty battery again. Installed LED wires in the side panels and the bottom of the arms are also illuminated and gives you some style at the next night's race.

Digital HD Experience - Caddx Polar

Equipped with the DJI Digital FPV system with 50mBit transmission for 720P video feed on your DJI FPV Goggles and range you've never expected with your old analog VTX. We are using the new CaddX Vista Polar HD system, installed in the back of your quad. The Polar camera offers better image quality than other CaddX cams. Better low light performance and more detailed shadows. In daylight similar to the Nebula Pro with improved dynamic range.

Specifications:

  • Total Dimensions: 136*190mm (body dimension)

  • Geometry: Squashed-X or DC (DeadCat) frame available
  • Bottom to top distance: 28mm

  • Arm Thickness: 6mm

  • Bottom plate thickness: 3mm

  • Top plate thickness: 3mm

  • Upper(middle) plate thickness: 3mm
  • XING2 2207 motors (4S/6S) 
  • Nazgul F5 propellers

  • Weight: 412g (without battery and GoPro mount)

FC // SucceX-D Mini F7

  • MCU: 216MHz STM32F722
  • Gyro:2x ICM20689
  • Blackbox:32MB
  • Betaflight OSD: YES
  • BEC: 5V 2.5A / 9V 2.5A
  • Current sensor scale:  100
  • Inverter for SBUS input (UART2-RX)
  • Smart audio & Tramp VTX protocol supported
  • Beeper pad: Yes
  • RSSI input pad: No
  • UARTs:5
  • Motor outputs: 4
  • 8 pin 4in1 ESC port (GND, VBAT, M1, M2, M3, M4, CUR, R5)
  • 6 pin DJI Air Unit port (R1, GND, R2, T2, GND, 9V)
  • BLHeli32 Telemetry:Yes
  • Input voltage:recommended 2-6S, MAX 6S
  • Firmware target: IFLIGHT_F722_TWING
  • Mounting pattern: 20*20mm φ3
  • Dimensions:   29*29mm
  • USB Type-C

ESC // SucceX Mini 55A 

  • Dimension: 31*29.5mm
  • Mounting Holes: 20*20mm/Φ4mm
  • Weight: 10.8g
  • Supports 2-6S Lipo input
  • MCU: G071
  • Constant: 55 Amps 
  • Burst: 60 Amps
  • Current sensor: Yes
  • BEC: No
  • Current rate: 100
  • Supports DShot DShot150/300/600/MultiShot/ OneShot etc.
  • Firmware: BLHeli 32
  • Target:  iFlight-G071-4IN1 

Package included:

  • 1 x Nazgul Evoque F5(Squashed X or Deadcat pattern)
  • 4 x Nazgul F5 Prop
  • 2 sets of Battery Pads
  • 4 x Battery straps
  • 1 x Screws bag

Browse more

Why Choose Phaser FPV?

Here’s Why 1000s of Buyers Trust Us

In the sky-high world of FPV drones and related products, Phaser FPV takes you higher and further – while ensuring a smooth ride every step of the way. As a human brand that puts its clients first, here are a few of the ways we keep giving our customers reasons to come back.

Same-Day Ship

If you place your order with us before 1pm weekdays, we’ll ship it out on the same day you shopped. When we make a promise, we keep it. You’ll be hard-pressed to find any Phaser order that didn’t fly out of our facility on the day it was ordered.


Transparent Stock

We keep our website updated like hawks. If you see it and it says it’s in stock, you can order it today and get it tomorrow via express shipping.

Highly Rated

We’ve spent almost a decade racking in countless 5-star reviews. Give them a read and you'll see everything we have said here is true!

Walk In Anytime

Can’t wait? Then don’t. We’re one of the only FPV drone + accessory stores to have a physical brick-and-mortar establishment in Gosford NSW Australia. You’ll get to meet one of our friendliest – and fluffiest – employees, the Phaser FPV house dog, Piper!

Fast Support

We welcome our customers to reach out to us via email, phone, or LIVE chat. Phaser FPV is the only FPV business to have a dedicated phone line.

We’re on Social

We have nothing to hide. Follow us on social, tag @PhaserFPV, and become a part of our online community and family in our facebook group.

It’s clear to see why most of our business comes through word-of-mouth referrals. When you need the best in FPV, 3D Printing and PEV Vehicles, don’t settle for less. Demand the best – insist on Phaser FPV.

Sunday,Monday,Tuesday,Wednesday,Thursday,Friday,Saturday
January,February,March,April,May,June,July,August,September,October,November,December
Not enough items available. Only [max] left.
Shopping cart

Your cart is empty.

Return To Shop

Add Order Note Edit Order Note
Estimate Shipping
Add A Coupon

Estimate Shipping

Add A Coupon

Coupon code will work on checkout page

USD

Select your currency

iFlight Nazgul Evoque F5 4S/6S w/Caddx Polar Vista HD System

4S / TBS Crossfire RX / F5D DeadCat Frame
4S / TBS Crossfire RX / F5D DeadCat Frame
$515.00