Last Updated 25-04-16
The following parts were selected

1x Bolt 250 Frame
1x Naze 32: Naze 32 Acro
4 x XNova 2204 2300kv motors
4x ZTW Spider Mini 18A OPTO ESC Multi-Rotor 2~4S (BLHeli/SimonK Firmware)
1x 
Foxeer HS1177 XAT600M DC5V-22V 600tvl Sony Super HAD CCD FPV Camera IR Block 2.8mm Lens PAL
1x 
Aomway T25 5.8GHz Selectable 25/200mW 40CH FPV Tx VTX
1x Aomway 5.8GHz RP-SMA FPV 4 Leaf Clover AV Transmission RHCP Antenna 1 Piece – Red
1
x Matek PDB BEC-5V/3A LED Lighting Control Tracker Low Voltage Alarm LED & POWER HUB 5in1
4x DAL Tri Blade T5045BN 5045BN Bullnose Propellers

1x FrSky XSR 2.4GHz 16CH ACCST Receiver with S-Bus and CPPM
1x FrSKY Taranis X9D Plus Mode 2 2.4Ghz Digital Telemetry Radio System With Alluminium Case (C’Tick Approved)

Pictures of progress

IMG_20160323_174251 (1)
Frame Put together, Motors mounted, Camera Mounted

IMG_20160323_164852
Pins Placed in Naze32
IMG_20160325_115801

Pins Soldiered in Naze Board

 

IMG_20160325_132027
PDB Board installed and wired to ESC power.

IMG_20160327_123642 IMG_20160327_123630

Inside a xnova motor

IMG_20160411_210801 IMG_20160411_211443IMG_20160401_214537

All setup with the X8R installed

IMG_20160401_222441IMG_20160419_200155

Ready for props!

 

IMG_20160420_211347

All cables clean

IMG_20160420_211337 IMG_20160420_211327

All setup and ready to fly!